Ynt: WJ p 0340 kodlu arıza nedır
P0340 (M)
Camshaft Position Sensor A Circuit (Bank 1 or Single Sensor)
A rationality error has been detected for loss of camshaft position sensor (no fuel sync).
WJ 1999 &' 2000: Check the camshaft target wheel (located on the right side camshaft sprocket) for damage or excessive runout.
The runout is very critical for proper camshaft signal input to the JTEC.
The lateral runout on the target wheel should not exceed 0.012 inch.
selamlar,
orjinali böyle diyor ,
benim anladığım kadarı ile eksantrik mili pozisyon sensoru yıpranmadan dolayı JTEC e doğru bilgi göndermiyor demek istiyor.
Syg.