Ynt: YARDIM - Disco 2 Anahtar Kumanda Etmiyor - İzmirden Usta Arıyorum....
Supercose' Alıntı:
Adnan abi selamlar ;
Aracın sorununu hallettik ama gene aynı arızayı yaptı.
Bu seferde EKA nın depo edildiği DCU unit ( DCA da olabilir tam emin değilim ) bloke oldu.
Neyse, bir şekilde bilgisayar ile DCU nun blokesini kaldırdık fakat bu sefer EKA yı giremiyoruz.
Özgörkey den EKA aldık, acaba sizin EKA kodlama yolunuz nedir ? Belki biz yanlış birşey yapıyoruz.
Yardım ederseniz sevinrim.
Teşekkürler
EKA girişi için orijinal metni aşağı kopyalıyorum, biraz yoğunum kusura bakmayın, gerekirse bir ara tercümesini de yazarım.
Kolay gelsin, son durumu yazın ltf.
Adnan
Emergency key access
If the handset is damaged, or fails to operate,the engine can be re-mobilised by using the key to enter a unique four number emergency key access code. The code is
recorded on the Security Information card and is entered as
follows:
1. Ensure that all doors are closed, then using the key turn the driver's door lock to
the UNLOCK position (towards the front of the car) and hold in this position for at least 5 seconds until the alarm sounder sounds once). Then return the key to the centre position. It is now possible to use the key to enter the separate numerical values of the four numbers that make up the emergency key access code.
2. Enter the FIRST number of the code. If the first number is 4, turn the key (towards the front of the car) to the UNLOCK position 4 times. Ensure the
key is FULLY returned to the centre position after each turn.
3. Enter the SECOND number of the code. If the second number is 3, turn the key
(towards the rear) to the LOCK position 3 times. Remember; the key must be FULLY
returned to the centre position after each turn.
4. Enter the THIRD number of the code. If the third number is 12, turn the key to the UNLOCK position twelve times, ensuring that the key is FULLY returned to the centre position after each turn.
5. Enter the FOURTH number of the code. If the fourth number is 1, turn the key to the LOCK position once. Ensure the key is FULLY returned to the centre position.
6. Finally, turn the key to the unlock position once more. If the code has been entered
correctly, a double ‘bleep’ will sound (a single ‘bleep’ indicates that the code has
been entered incorrectly).
NOTE: If the Mislock audible warning has been deselected (by a Land Rover dealer), the alarm sounder will not sound when an EKA code has been entered. Instead, the alarm indicator light on the instrument panel will flash once (for one second) to indicate a successful code entry.
There is now a five minute delay before the alarm and engine immobiliser are deactivated. DO NOT OPEN THE DOOR OR ATTEMPT TO ENTER THE VEHICLE YET!
7. Through the driver's door window, observe the anti-theft alarm indicator light on the instrument panel. If code entry was successful, this light will continue flashing (once every two seconds) for the five minute delay period. DO NOT OPEN THE DOOR OR ATTEMPT TO ENTER THE VEHICLE until the full delay period
has elapsed - this will be indicated by the anti-theft alarm indicator light extinguishing.
8. Now open the door, insert the key into the starter and turn the switch to position ‘II’
IMMEDIATELY! If the starter switch is not turned to position ‘II’ within 30 seconds of the indicator light extinguishing, the engine will automatically immobilise again.
If an incorrect code has been entered: If an incorrect code has been entered, the alarm sounder will sound once and the anti-theft alarm indicator light will continue to flash. In this case, return to operation ‘1’ and re-enter the code. After three failed entry attempts, the security system invokes a delay period of ten minutes during which the system will not accept any further attempts to enter a code.
IMPORTANT INFORMATION
Memorise the emergency key access code or keep the Security card on your person in case of emergencies. NEVER leave the card in the vehicle.
